Cleaning out Storage Space and have MGB Parts

[Martin Keller]

Ok all of you MGB owners I have some parts [USED] that I do not need to keep any more due to not having an MGB or car that can use the spare parts that I have kept as a reserve in case I needed them.
Here is a short list so if you need something send me a PM and I will let you know if I have what you need.
Four Speed Transmission still mounted to the engine. came out of a 74. [Now at Steve's]
A couple water pumps in fair shape.
Engine push-rod covers front (flat) and back (with breather).
Electric Fan for radiator that works.
Thermostat housings.
Radiator bulkhead for an MGB. Not bent or rusted.

Maybe I will get some photos and post them.

If you need it let me know otherwise it will most likely end up going to the scrap guy as I do not want to store it or keep it any longer.
Getting closer to giving it to the scrap guy so if you need it let me know soon.



edited to Updated status 01/13/14 8am
edited to remove oil filter mount. 01-14-14 10pm

[VWNate1]

Oops ~ kinda late here .

If you're tossing it , I'll happily take the cylinder head as I have an 1800 engine that needs one .

Let me know and i'll trot on out the The valley and grab it soon .

I could also use an early rubber seal timing cover and pulley as the dripping from the old felt seal ring is annoying .

TIA ,

[Martin Keller]

Nate the head is already spoken for. You can have the timing chain cover off the block I have if you want to take the block and trans that is attached to it. It is on a stand that rolls if that helps.

[Steve Simmons]

Wow, didn't realize you were just giving it all away. I would have told you to drop the lump here!

[Martin Keller]

Wow, didn't realize you were just giving it all away. I would have told you to drop the lump here!

Hi Steve,
Not giving it all away but I don't need the block or the trans and if someone can use it or part of it and wants to come get it I would be glad to have it out of my garage. So you and Nate can fight over it or I have been known to take a case of beer in trade for things.

[Steve Simmons]

If someone has a need then that's where the parts should go. But if no one takes it then I'm happy to give it a home. I just hate to see potentially useful parts end up in a recycling yard!

[VWNate1]

All I need is the sheet metal timing cover and pulley ~ give the lump to Steve as my back yard is full of junk now .

[Martin Keller]

All I need is the sheet metal timing cover and pulley ~ give the lump to Steve as my back yard is full of junk now .

Hi Nate and Steve,
Maybe I should take the lump to Steve's and the two of you can figure out how to part it out.
Let me know.

Have a good day.

[VWNate1]

That sounds right to me .

I can't lift anything right now , awaiting the Neurosurgeon .

[Martin Keller]

Updated parts list.

Getting ready to give to the scrap guy soon.

[Stewart]

what style oil filter mount?

[Martin Keller]

what style oil filter mount?

Hi Stewart,

Moss Motors P/N 460-910 for the inverted spin on filter type.
If you want it send me a PM and I will mail it to you.

[Martin Keller]

Stewart did the filter mount work. I hope so.

[VWNate1]

Anyone have a dead 1800 engine I'll happily take it away , I need the ancillary things : oil pump and intake screen complete , spin on oil filter etc. ~

I got a three main bearing 1800 and will overhaul it for my beloved Met FHC as soon as I'm able , should be this Summer .

I know someone has a rusty lump sitting in the weeds.....